SOFTPAQ NUMBER:  SP9543
PART NUMBER:  N/A
FILE NAME:  CPQDISP.DLL
TITLE:  Deskpro Specific Models Display Support for NT 4.0
VERSION:  3.24 Rev B
LANGUAGE:  English

CATEGORY:  Drivers

DIVISIONS:  Desktops

PRODUCTS AFFECTED:  Deskpro models with one of the graphics controllers 
                    listed below in the "System Configuration" section.

                    This may include the following models:
                    Deskpro    450, 466, 575, 590, 4100, 5100, 5120, 5133, 5150, 5166;
                    Deskpro XL 450, 466, 575, 590, 5100, 5120, 5133;
                    Deskpro 2000 Series (including MMX); 
                    Deskpro 4000 Series (including MMX)
                     
NOTE:  To determine whether your unit has a video controller
       supported by these drivers, go to Control Panel/Display/
       Settings/Display Type.

OPERATING SYSTEM:  Microsoft Windows NT 4.0

SYSTEM CONFIGURATION:  Using one of the following graphics controllers:
                       S3 V2/GX
                       S3 ViRGE/GX 
                       Cirrus 5434
                       Cirrus 5436
                       Cirrus 5446 
                       QVision 1280/P
                       QVision 1280/P+ 

PREREQUISITES:  N/A

EFFECTIVE DATE:  February 16, 1999

ELECTRONIC DISTRIBUTION ALLOWED:  Yes

SOFTPAQ UTILITY VERSION:  4.x

SUPERSEDES:  SP7948

DESCRIPTION:  This SoftPaq unpacks the files required to install 
the video driver for Windows NT 4.0 for the S3 V2/GX or ViRGE/GX 
controller used in certain Deskpro models.  It also supports previous 
Cirrus 5434/36/46 and Qvision 1280/P and 1280/P+ graphics controllers.  

Optionally allows a driver diskette to be created.

Enhancements/Fixes:
 - Fixes problem where Lotus Notes 4.5 and 4.6 caused lockup when 16 million 
   colors were selected.
 - Adds support for the System Software Manager tool

HOW TO USE:

1. Download the SoftPaq to a temporary, empty directory on your 
hard drive.  The file downloaded is a self-extracting executable 
with a filename based on the SoftPaq Number above.

2. From the download directory, execute the SoftPaq.  When executed 
with no parameters, files are extracted into the current directory.
To extract the files into a different directory, specify the complete 
path of the directory as a parameter:

     SPxxxx <path> 

Enter "Y" to confirm and files are unpacked into the download 
directory or the directory specified.  

3. After the files have been created, you may delete the  
self-extracting file downloaded in step 1.

4. The driver may be installed directly from the files on the download 
directory or driver diskette can be created. To create a driver diskette,
run MAKEDISK.BAT.
To install the driver, go to the Control Panel and select:

   Display/Settings/Display Type

Verify that the Adapter Type is one of the ones listed above.
If it is not, then cancel and exit.
If it is, then continue to select:
    
   Change/Have Disk

Type in the path to the download directory or select "Browse" to 
specify the location of the files extracted in step 2.

5. Select OK to install the driver.

6. After the driver has been installed, you may delete the files 
from the download directory if you wish.

Copyright 1999, Compaq Computer Corporation.  All rights reserved.

Product names mentioned herein may be trademarks and/or registered
trademarks of their respective companies