SOFTPAQ NUMBER:  SP6877
PART NUMBER:  N/A
FILE NAME:  N/A
TITLE:  Deskpro ATI Rage Video Drivers for Windows 95 
VERSION:  5.03B20a Rev A
LANGUAGE:  Finnish

CATEGORY:  Drivers

DIVISIONS:  Desktops

PRODUCTS AFFECTED: Compaq Deskpro EN, Deskpro EP, and Deskpro SB models with 
                   one of the ATI Rage Graphics Controllers listed below 
             NOTE: To determine if your model has one of these controllers --
                   In Windows 95, go to the Control Panel, then select the 
                   System icon, the Device Manager tab, and the Display 
                   adapters icon.

OPERATING SYSTEM:  Microsoft Windows 95

SYSTEM CONFIGURATION:  ATI Rage Pro Turbo 1x or 2x Graphics Controller
                       ATI Rage IIC Graphics Controller

PREREQUISITES:  To obtain 132 column support (Modes 109, 10A, 10B, 10C) you 
must upgrade the video ROM on a Rage Pro Turbo Graphics Controller with
upgrade software from one of the following SoftPaqs:
     SP6868 for the Rage Pro Turbo 1x
     SP6869 for the Rage Pro Turbo 2x

EFFECTIVE DATE:  May 22, 1998

ELECTRONIC DISTRIBUTION ALLOWED:  Yes

SOFTPAQ UTILITY VERSION:  3.1

SUPERSEDES:  SP5793

DESCRIPTION:  Unpacks the files needed to install the Windows 95 video drivers for 
any of the ATI Rage Graphics Controllers listed above, which are used in certain 
models of the Deskpro EN, Deskpro EP, and Deskpro SB Series.  
Optionally allows two installation diskettes to be created.  

Enhancements/Fixes: 
 - Adds 132 column support.
 - Adds legacy 16-bit application support.

HOW TO USE:

1. Download the Softpaq to a directory on your hard drive.  The file downloaded is 
a self-extracting executable with the file name based on the Softpaq Number above.

2. From the download directory, execute the SoftPaq.  When executed with no 
parameters, files are extracted into new folders that are created in the current 
directory.   To create the folders in a different directory, specify the complete 
path of the directory as a parameter when executing the SoftPaq:

   SPXXXX <path>

Enter "Y" to confirm and files are unpacked into subdirectories named 
Disk_01 and Disk_02 that are created under the download directory or the 
directory specified.  

3. After the folders Disk_01 and Disk_02 have been created, you may delete the 
self-exctracting file downloaded in step 1.

4. The drivers may be installed directly from the folders on the download 
directory, or two driver installation diskettes can be created.  

To create installation diskettes, run MAKEDISK.BAT.

To read detailed installation and usage instructions, refer to README.TXT.

5. To install a driver, run SETUP.EXE. 
For example, select Start, Run, then enter:

   <path>\disk_01\setup

   where <path> is the drive and directory chosen in step 2 

Or, if installing from diskettes, enter:

   a:\setup

Follow the on-screen instructions to complete the installation.

Copyright 1998, Compaq Computer Corporation.  All rights reserved.

Product names mentioned herein may be trademarks and/or registered
trademarks of their respective companies.