SOFTPAQ NUMBER:  SP5027
PART NUMBER:  N/A
FILE NAME:  N/A
TITLE:  Deskpro 2000MMX/4000MMX Display Support for NT 4.0
VERSION:  3.21 Rev C
LANGUAGE:  Korean

CATEGORY:  Desktops/Drivers

PRODUCTS AFFECTED:  Deskpro 2000MMX/4000MMX Series with one of the 
                    graphics controllers listed below.
                     
NOTE:  To determine whether your unit has the video controller
       supported by this driver, go to Control Panel/Display
       /Settings/Display Type.

OPERATING SYSTEM:  Microsoft Windows NT 4.0

SYSTEM CONFIGURATION:  Using one of the following graphics controllers:
                       S3 V2/GX
                       S3 ViRGE/GX 
                       Cirrus 5434
                       Cirrus 5436
                       Cirrus 5446 
                       QVision 1280/P
                       QVision 1280/P+ 

EFFECTIVE DATE: 23 December 1997 

ELECTRONIC DISTRIBUTION ALLOWED:  Yes

SUPERSEDES:  SP4804

DESCRIPTION:  This SoftPaq unpacks the files required to install 
the video driver for Windows NT 4.0 for the S3 V2/GX or ViRGE/GX 
controller used in certain Deskpro 2000MMX/4000MMX  models.  It also 
supports previous Cirrus 5434/36/46 and Qvision 1280/P and 1280/P+ 
graphics controllers.  Optionally allows a driver diskette to be 
created.

This version fixes the following problems:
  - Test screen color is corrupted at 1280x1024x16 and 1152x864x16. 
  - Full screen mode causes bottom bar to turn black at 320x400.
  - Small black lines appear in Fox&Bear (limited mode only).
  - HCT test fails at 1024x768x16 and 1152x864x16.
  - Page fault occurs in the HCT check resolution test.

HOW TO USE:

1. Download the SoftPaq to a temporary, empty directory on your 
hard drive.  The file downloaded is a self-extracting executable 
with a filename based on the SoftPaq Number above.

2. From the download directory, execute the SoftPaq.  When executed 
with no parameters, files are extracted into the current directory.
To extract the files into a different directory, specify the complete 
path of the directory as a parameter:

     SPxxxx <path> 

Enter "Y" to confirm and files are unpacked into the download 
directory or the directory specified.  

3. After the files have been created, you may delete the  
self-extracting file downloaded in step 1.

4. The driver may be installed directly from the files on the download 
directory or driver diskette can be created. To create a driver diskette,
run MAKEDISK.BAT.
To install the driver, go to the Control Panel and select:

   Display/Settings/Display Type

Verify that the Adapter Type is one of the ones listed above.
If it is not, then cancel and exit.
If it is, then continue to select:
    
   Change/Have Disk

Type in the path to the download directory or select "Browse" to 
specify the location of the files extracted in step 2.

5. Select OK to install the driver.

6. After the driver has been installed, you may delete the files 
from the download directory if you wish.

Copyright 1997, Compaq Computer Corporation.  All rights reserved.

Product names mentioned herein may be trademarks and/or registered
trademarks of their respective companies