SOFTPAQ NUMBER:  SP10406
PART NUMBER:  N/A
FILE NAME:  N/A
TITLE:  Workstation Matrox Millennium II/G200/G100 MMS Drivers for Windows NT 4.0
VERSION:  4.12 Rev A
SIGNIFICANT FILE VERSION:  4.00.1381.4100
VENDOR VERSION NUMBER:  4.12.043
LANGUAGE:  English

CATEGORY:  Drivers

DIVISIONS: Workstations

PRODUCTS AFFECTED:  Compaq Professional Workstations 6000, 8000, 5100, AP200, 
                                                     AP400, AP500, SP700

	    NOTE:   The graphics controllers listed below are standard equipment 
                    on selected Workstation models only, but could be an option 
                    installed on other models.

OPERATING SYSTEM:  Microsoft Windows NT 4.0

SYSTEM CONFIGURATION:  Millennium II Graphics Controller (PCI), 
                       Millennium G200 Graphics Controller (PCI or AGP), 
		       or Productiva G100 MMS Graphics Controllers

PREREQUISITES: You must install Microsoft Windows NT Service 
   Pack 3 (or higher) before you install the driver for the 
   Matrox Productiva G100 Multi-Monitor Series Graphics Controller. 

EFFECTIVE DATE:  December 1, 1999

ELECTRONIC DISTRIBUTION ALLOWED:  Yes

SOFTPAQ UTILITY VERSION:  4.x

SUPERSEDES:  SP9909

DESCRIPTION:  This SoftPaq creates a set of files that provide 
support for the following subsystems and features of Compaq 
Professional Workstations:
 
   Matrox Millennium II PCI Graphics Controller
   Matrox Millennium G200 PCI Graphics Controller
   Matrox Millennium G200 AGP Graphics Controller
   Matrox Productiva G100 MMS Graphics Controller
   
ENHANCEMENTS/FIXES:
   
 - This Softpaq is SSM Compatible.
 - Additional support for the Matrox Productiva G100 Multi-Monitor Series 
   Graphics Controller. 
 
HOW TO USE:

1. Download the SoftPaq to a directory on your hard drive.  The 
file that is downloaded is a self-extracting executable with a 
filename based on the SoftPaq Number above.

2. From that drive and directory, execute the downloaded file 
and follow the on-screen instructions to unpack the files.
The number of files to be created and total file size is displayed.
You will be given the chance to specify the target directory for 
the files, or default to the download directory.

3. After the files have been created, you may delete the  
self-extracting file downloaded in step 1.

4. From the directory in which the files are created, execute the 
setup command below to start the installation of Software.

	SETUP.EXE  [ENTER]


Copyright 1999, Compaq Computer Corporation.  All rights reserved.

Product names mentioned herein may be trademarks and/or registered
trademarks of their respective companies.