Softpaq Solution:  SP1012
File Name:  P/N 177140-001
Title:  Display Driver Support for OS/2 
	using the Compaq/CL34 Graphics Controller
Version:  1.01
_______________________________________________________________________ 

	
CATEGORY:  Drivers

EFFECTIVITY DATE:   8-26-94 

PRODUCTS AFFECTED:   Presario  500 systems.

OPERATING SYSTEM:  MS-DOS 5.0 or greater

SYSTEM CONFIGURATION:  MS Windows 3.1 

SUPERCEDES: NONE  (New product release)

DESCRIPTION: This  release provides Display driver support for OS/2 v2.1
using the Compaq/CL24 Graphics Controllers.



HOW TO USE: 

1. Obtain a formatted 1.44 MB diskette.

2. If SoftPaq obtained on diskette, copy the SoftPaq file to a temporary
   directory on the hard drive and go to that directory:

     MD C:\CPQ
     COPY A:\SP1012 C:\CPQ
     C:
     CD \CPQ

   If SoftPaq downloaded from BBS, go to the directory where downloaded
   to: 
      C: CD \CPQ 

3. From that drive and directory, run the SoftPaq utility to unbind the
   primary files.  SP0904 (and press ENTER) The following files should
   be created: 

     177140EN._01
     177140EN.DOC
     177140EN.CVR
     QRST.EXE 
 
4.  Create the diskette image by running this command at the DOS prompt:

     QRST (and press ENTER)

5. The "Choose the Transfer Type..." prompt appears.  Choose the
   highlighted, default selection "All diskettes in the Set" by pressing
   ENTER.

6. The "You will need to have the specified number of each type(s) of
   pre-formatted media..." prompt appears.  It is asking for one 1.44 MB
   diskette.  

Verify that you have a formatted 1.44 MB diskette and press ENTER to
accept and continue.  

IMPORTANT: Only a 1.44 MB diskette can be used, other types of media
	   cannot be substituted.

7. The "Create diskette number one, insert a 1.44 MB diskette into drive
   [A] or [B]" prompt is given.  (Either A or B will be included in the
   prompt, depending on where your 3.5 inch diskette drive is located.

If the drive shown in the prompt is not the one you wish to use, change
the value by pressing either A or B.

At this point, you can optionally print a label (if your printer is
attached) by pressing F5.

To begin diskette creation, press ENTER.

8. A counter box will be displayed during creation showing status. The
   number of cylinders will count up to 80.

9. When QRST has completed, it will exit back to DOS with the message:

     "QRST: Transfer Completed"

10. At this point, the Driver Support diskette has been created and is
    ready to use for upgrading.

11. Please read all READMEs before installing this new driver.